1. Dear Drugs-Forum readers: We are a small non-profit that runs one of the most read drug information & addiction help websites in the world. We serve over 4 million readers per month, and have costs like all popular websites: servers, hosting, licenses and software. To protect our independence we do not run ads. We take no government funds. We run on donations which average $25. If everyone reading this would donate $5 then this fund raiser would be done in an hour. If Drugs-Forum is useful to you, take one minute to keep it online another year by donating whatever you can today. Donations are currently not sufficient to pay our bills and keep the site up. Your help is most welcome. Thank you.
    PLEASE HELP

Experiences - Smoking Oxycodone (CWE from percocet)

Discussion in 'Oxycodone' started by RoboJesus, May 3, 2010.

  1. RoboJesus

    RoboJesus Silver Member

    Reputation Points:
    10
    Messages:
    13
    Joined:
    Oct 9, 2005
    from U.S.A.
    I recently decided to find out if he could get high smoking oxycodone obtained via a cold water extraction from percocet (5/325).

    Background
    SWIM enjoys smoking oxycontin off of tin foil quite a bit, it is his favorite ROA and his DOC. Unfortunately for SWIM, he has no way to acquire a prescription for oxycontin nor can he afford the outrageous prices that OCs cost on the street. I do, however, have a prescription for 90 percocet (5/325) each month. Usually I am content to take his medication as prescribed but he also likes to have some fun and experiment from time to time. This is one of those times :)

    I am not going to go into the process for performing a cold water extraction on percocet because that has been covered plenty of times. I used 9 tablets containing 5 milligrams of oxycodone and 325 milligrams of acetaminophen as well as a ton of binders and fillers. After the extraction I was left with about 60ml of nearly clear liquid which he poured onto a pyrex baking dish to evaporate. In order to facilitate this process SWIM placed a desk lamp about 4 or 5 inches above the surface of the pyrex dish so that the heat from the incandescent bulb would speed up evaporation. I know that oxycodone is supposed to be sensitive to heat and light but neither proved to be a problem in the end.

    After all the water had evaporated I was left with a dish coated in white crystals and powder which he scraped off with a razor blade into a big pile. Obviously this was nothing close to pure oxycodone because even with a 100% yield I would only have 45mg of oxycodone and the amount of powder/crystals was many times that.

    I got out his trusty tin foil and straw and decided to try it out. He was unable to make the powdery stuff stick together very well so he scooped up a large pile and put it onto a piece of foil. SWIM suspected that it would burn better if he could somehow make it behave as one piece rather than a pile of powder so I used the oral syringe to put one small drop of water on top of the pile and noticed that the powder LOVED the water. SWIM then proceeded to use the tip of the syringe to push the powder towards the water droplet and added another drop or two until all the powder was combined in a wet lump. SWIM then heated under the lump with a lighter until the water evaporated and a small amount of smoke was produced. I smoked it as if it were a piece of black tar or an oxycontin pill and was very pleased with the results. SWIM noticed that the taste was somewhat reminiscent of oxycontin but it tasted worse but not intolerable. I got really high from smoking all of the extract and will probably repeat this experiment in the future if he feels like smoking oxycodone.